If the dust cap of a speaker has been pressed in, the dust cap will look ugly and will make the speaker not look at its best. However, if the dust cap of a speaker is pressed in by accident, it it will not effect the performance of the speaker itself. If the dust cap is cracked, that can cause dust to enter into the voice coil, which can cause it to stiffen up, that can reduce the driver's performance. Anyways, if you dislike your speaker because of the dust cap is pressed in, you can repair it using your household vacuum cleaner.
To unsuck the speaker dust cap, connect the vacuum cleaner to an electrical outlet and the switch it on. Then switch on the hoover and if possible, reduce the power of the hoovers suction power, as too much power can tear the dust cap and make the situation worse. Hold the hoover nozzle and then place it on the area were the dust cap is pressed in. Hopefully the area of the dust cap that is pressed in should be fixed. When it is fixed, turn off the power, this is to turn off the hoover. Don't pull the nozzle off the dust cap when the hoover is turned on because you're likely to tear the dust cap, so make sure you remember that!
If for some reason you don't have hoover that is available, if you have masking tape, you can use that to repair the pressed in dust cap. Don't use tape that is super strong, like 'Duct tape', as that will tear dust cap. Tear off a sensible amount of masking tape off the role, then place it on the area were the dust cap has been pushed in. Then slowly peel off the masking tape and the dented dust cap will be fixed!!
0 comments:
Post a Comment